IPB

Welcome Guest ( Log In | Register )

> Rims heating elememt
Kansan
post May 6 2012, 04:44 PM
Post #1


Homebrewer
**

Group: Members
Posts: 15
Joined: 7-April 08
Member No.: 11,832



Looking for a rims heating element less than 4500w that is low density, and at least 13in before it folds back (could be as long as 17in) to fit my element tube. Would like it to be a stainless or nickle finish, not a fan of the black incoly or "lime-life" sheathings on so many elements. I found a Camco 3500w ld but is only 7" at the fold, seems pretty short to really be a low density with wort flow. Any ideas on where to find one?

Thanks,
Kansan
Go to the top of the page
 
+Quote Post
 
Start new topic
Replies
Dean Palmer
post Feb 27 2013, 04:30 PM
Post #2


Brewmaster
*****

Group: Members
Posts: 1,280
Joined: 2-February 07
From: St Petersburg, Florida
Member No.: 8,306



Been running a 4500 ULWD element on 120v for a few years now in my RIMS tube and there is never any scorched wort, even when the pumps lose prime for a little bit. It currently runs of a simple Ranco controller and no fancy pulsing relays (yet) but as long as there is liquid in the tube it works well. My element and tube is always clean and never takes more than the sparge water rinse to clean it acceptably. I'd wonder what folks are doing different as I've sure made a few mistakes where the wort sat and boiled a bit with no pump :-)
Go to the top of the page
 
+Quote Post

Posts in this topic


Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 24th January 2021 - 05:08 PM